At 01:50 PM 03/10/2000 -0500, you wrote: >Jeannie: > Steve's description of the agraffes is right on. One other thing I >found is that the bolt end was a bit short compared to current replacements, >and that the plate wasn't tapped deep enough to take the new agraffes without >straining some of them. You will need to use a tap to cut the plate threads a >little deeper. It'll make the job much easier when you don't have to worry >about popping off the new agraffes! > Ed Sutton > It's a good idea to always run a tap through when replacing an agraffe. Jon Page
This PTG archive page provided courtesy of Moy Piano Service, LLC