Greg, If your bit chattered it may have been the direction that you moved the tool. The thick tacky tape that I use makes up for the crown. Joe Goss imatunr@srvinet.com www.mothergoosetools.com ----- Original Message ----- From: "Greg Newell" <gnewell@ameritech.net> To: "Pianotech forum" <pianotech@ptg.org>; "Master Piano Tech" <mpt@talklist.com>; "College and University Technicians" <caut@ptg.org> Sent: Monday, April 30, 2001 1:58 PM Subject: Soundboard shims via Spurlok method > Dear Lists, > I've got trouble. I just started using the sound board router system > the venerable Mr. Bill Spurlock sells. I don't like it! Maybe it's just > me but I can't get a handle on how to affix a rail to the crowned sound > board. I would be easier if the board was flat bu then I'd be replacing > it not shimming it. I've always been taught that a glue joint is only as > good as the mating surfaces. I have several small gaps in various places > and I've gone as wide as I dare with the shims that I have. Kind of like > the wobbly chair syndrome. I've never had a router bit cut so poorly, > chattering and pulling like it did. > I am gluing the shim in now with as much of the gaps minimized as > possible but I'm finicky. I'd rather not see any at all. I think I'll > switch gears here and try the epoxy method. Would any of you be so kind > as to detail this method to me along with the product you use and your > results with it. Before the forum police come to get me, I know this has > been posted before. Nevertheless I'd appreciate a complete approach if > any of you are so inclined. > Thanks a bunch! You all are the best!!!! > > Greg > -- > Greg Newell > Greg's Piano Forté > 12970 Harlon Ave. > Lakewood, Ohio 44107 > 216-226-3791 > mailto:gnewell@ameritech.net >
This PTG archive page provided courtesy of Moy Piano Service, LLC