Wim, Yeah, the ya da ya da. If you'll leave those hammer shanks at about 4 swings, your pianists will adore you. I just repinned our concert grand which was swinging about 7 or 8 times because the pianists couldn't get any control. I repinned at from 2 to 4 swings after "working" them. Improved the tone miles and miles, too. Yeah, I live in the humid South, too. If gravity will pull it down it ain't too tight. Jeff >We all know that a hammer is supposed to swing 4 - 8 times. If it is less >than 4, then the bushing is too tight. If it's more than 8, supposedly the >bushing is not tight around the pin, and that might cause the hammer to >wobble up to the string, which will eventually lead to uneven wear on the >hammer, whcih creates tone problems, ya da, ya da. > > So here is the problem. I've got this hammer with only 3 swings. So that >mean the bushing is too tight. Before I take the pin out, ream the >bushing, and put in the same size pin, I put a little Protec on the >bushing. But now, all of a sudden, I've got 10 - 12 swings. According to >the above presumption, the bushing is now not tight around the pin any >more. > > Or is it? Has the introduction of Protec shrunk the bushing to the point >I need to ream and repin with a larger pin? Or do I leave the original pin >in there, and allow the 10- 12 swings? > > Wim > >
This PTG archive page provided courtesy of Moy Piano Service, LLC