This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Avery, Sorry I don't have any suggestions for you, I just hope that never = happens to me! (I avoid Baldwins where ever possible :-) I do have a = question, though. What is the fit of your hammer like on the tuning = pins? I've wondered if having a very close fitting tip will aid in the = prevention of broken TPs at the becket hole area. Any thoughts? For = years I've used a #3 Schaff tip whenever possible to get a close fit to = the coil. It can feel a little sloppy to some, but I've grown accustomed = to it. Thoughts? Joseph Alkana RPT josephspiano@attbi.com ----- Original Message -----=20 From: Avery Todd=20 To: caut@ptg.org=20 Sent: Thursday, January 31, 2002 5:24 AM Subject: Broken TP List, Anyone have a good way to extract a broken tuning pin on a new Baldwin Hamilton? There's about 1/4" still extending beyond the plate but it's EXTREMELY tight in the block! I've never had this happen to me and actually, this information is for another tech. Any brilliant ideas out there? Thanks. Avery ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/caut.php/attachments/4a/c7/94/0e/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC