Mark, Consider rolling one pin bottom between 2 bastard files, i.e. roughing it up and see if that gives you a tighter fit....I've never done it but.... David Ilvedson ----- Original message ----------------------------------------> From: Mark Cramer <Cramer@BrandonU.ca> To: CAUT <caut@ptg.org> Received: Mon, 30 Aug 2004 18:44:17 -0500 Subject: [CAUT] sizing key-frame pin holes? >we're having to replace a set of nicked .146" front-rail pins and have >replacements on hand, however, the new ones are a loose fit in the original >holes. >i.e.: not wobbly, but they can be pushed in and turned with bare hands. >I was thinking of pre-sizing the holes with hide glue ... any >cautions/suggestions? >thanks, >Mark Cramer, >Brandon University >_______________________________________________ >caut list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC