This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Wim, =20 Those bushings are easy enough to change - call Yamaha, get a few extra sets. =20 Don -----Original Message----- From: caut-bounces@ptg.org [mailto:caut-bounces@ptg.org] On Behalf Of Wimblees@aol.com Sent: Tuesday, January 11, 2005 12:56 PM To: caut@ptg.org Subject: Re: [CAUT] pedal pin In a message dated 1/11/05 2:36:09 P.M. Central Standard Time, DMannino@kawaius.com writes: Wim, =20 If you can't swage (swedge?) (i.e., smash with hammer) the pedal to tighten things up, I'd replace the pedal. A large pin will be a problem in the hinge brackets. =20 Don Mannino Thanks, Don, for that advice, but that brings me to another problem. The hinge brackets are fine, but the pedal pin is set in a plastic bushing, which is also worn out. The left pedal has the same problem. (I think I exchanged them once before, so now they're both worn out.) =20 I guess maybe a whole new set of everything is the best solution. Unless someone has a better plan. =20 Wim=20 ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/caut.php/attachments/3e/84/11/3e/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC