---------------------- multipart/alternative attachment Hey, Roger: Just for what it's worth, I was paying attention, too!!!! Ed ----- Original Message ----- From: Roger Jolly To: College and University Technicians Sent: 3/23/2005 11:04:10 PM Subject: Re: [CAUT] D complimented Hi Vince, Use a small drill bit in a pin vice. A little hard on the fingers but worth the effort. Make sure you have a nice sharp drill bit. The nice thing about Robertson screws, is that they are self grip, and easy to get in under the lip of the Dag. At least some one is really paying attention ;-) Regards Roger At 07:25 PM 3/23/2005, you wrote: Roger, how did you drill the hole(s) for the screw(s) in the dog(s)? Roger Jolly <roger.j@sasktel.net> wrote: Hi Wim, I have added Dag screws to the D's I look after. It makes voicing a lot easier I can quickly push the action into position, and not have to worry about cheek blocks and the sustenuto rod giving problems. After voicing, I back the screws inwards a quarter of a turn. Vince Mrykalo RPT University of Utah Do you Yahoo!? Yahoo! Small Business - Try our new resources site! ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/caut.php/attachments/d3/19/57/14/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC