---------------------- multipart/alternative attachment The dag has already been attached for you the factory. ----- Original Message ----- From: To: caut@ptg.org Sent: 3/24/2005 11:32:30 AM Subject: Re: [CAUT] D complimented In a message dated 3/23/05 10:04:31 P.M. Central Standard Time, roger.j@sasktel.net writes: Hi Vince, Use a small drill bit in a pin vice. A little hard on the fingers but worth the effort. Make sure you have a nice sharp drill bit. The nice thing about Robertson screws, is that they are self grip, and easy to get in under the lip of the Dag. At least some one is really paying attention ;-) Regards Roger This might be a "duh" question, but how do you attach the dag to the keybed? If it attached by a screw, wouldn't it be easier remove the dag, install the set screw, and then put it back? Wim ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/caut.php/attachments/fd/7e/71/e3/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC