[CAUT] My Loose Screw

[Cy Shuster]

You hinted that tightening the cheek blocks caused the problem.  So I'd 
guess you shimmed between the bottom of the cheek block and the keybed, to 
keep it from moving down so far when tightened.

--Cy--

----- Original Message ----- 
From: "Joe And Penny Goss" <imatunr at srvinet.com>
To: <ilvey at sbcglobal.net>; "College and University Technicians" 
<caut at ptg.org>
Sent: Monday, August 07, 2006 11:39 AM
Subject: [CAUT] My Loose Screw


> Hi David,
> Nope not under the bar.
> I can not figure out how it went out under the other subject.
> The key slip area seems like a good choice but does not work as easily as
> the cheek block area that Cy suggested.
> My question to him was where? On the cheek block.
>
> Joe Goss RPT
> Mother Goose Tools
> imatunr at srvinet.com
> www.mothergoosetools.com