I know that Steinway glues their hammers to the shanks at 5-1/8". Where is that measured??? I had always thought it was from the center pin to the mid-line of the hammer. I'm putting on new hammers on a D and the treble hammers are 5" from center pin to mid-line, and it tapers to even shorter at the bass end. I'm going to leave the treble hammers at 5" or I'll run into action placement problems, however the tails of the bass hammers are pretty close to the wippen (OK repetition!) and I'd like to move them out to be the same as the treble hammers. Can anyone see a problem waiting to happen here? In the morning (when the key bushing glue is dry) I'm going to dry fit samples to try them but I thought I'd check with the combined wisdom of the list. Thanks! dave __________________________ David M. Porritt, RPT Meadows School of the Arts Southern Methodist University Dallas, TX 75275 dporritt at smu.edu <mailto:dporritt at smu.edu> -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/caut.php/attachments/20060606/d9cdd3ee/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC