Hi Alan, short answer; we never ream tuning-pin holes... right idea/wrong application IMHO. Our simple recipe: reverse-grip tuning-pins: one-size over spare box of two-sizes over "on deck" torque-test all pins in reverse direction, on completion spot-pin any that fall below your specification. footnotes: 1.) We've never had a "viable" pinblock yield unsatisfactory results with this method. 2.) Our personal experiments with reaming were a disappointment. 3.) The combined effect of powering-out the old, and driving in the new pins seems to take care of any concerns of residue (pin-block treatment, etc.) coating the wood fibre. Your welcome to call Alan, if you want to exchange any further thoughts/experiences. thanks, Mark Cramer Brandon University -----Original Message----- From: caut-bounces at ptg.org [mailto:caut-bounces at ptg.org]On Behalf Of Alan McCoy Sent: Wednesday, August 15, 2007 10:48 AM To: College and University Technicians <caut at ptg.org> Subject: [CAUT] Reaming block? Hi Folks (at least those of you still out there), I'm about to repin a not-too-old pinblock. It had 2/0 pins and I'm gonna use LoTorq 3/0 pins. The block felt fine. I'm restringing because of other issues with this piano - wildly mismatched bass strings, false beats and such. I'd like to find out how other folks treat the block before re-pinning. Anyone ream? With what type of bit? I have tried reaming with a double-fluted reamer in the past but didn't like the results. Too inconsistent. I've also just done nothing to the block, with good results. Your thoughts would be appreciated. Thanks. Alan -- Alan McCoy, RPT Eastern Washington University amccoy at mail.ewu.edu 509-359-4627
This PTG archive page provided courtesy of Moy Piano Service, LLC