Why are you driving them so far through the block? When they go that far, they must be pushing the jack away from the block. Do you have a support between the keybed and the floor? Ed Sutton -----Original Message----- >From: daniel carlton <hacicspe at gmail.com> >Sent: Feb 3, 2007 7:17 PM >To: college and university technicians <caut at ptg.org>, pianotech mailing list <pianotech at ptg.org> >Subject: [CAUT] driving tuning pins on a samick grand > >hi list > >i'm driving tuning pins on a samick grand. i have the PB supported with >the PB support from Schaff, but the bottom lamination is separating from the >PB. i've included pictures. i've got the nuts on the PB support as tight as >they'll go, but the separation still happens. i've made my through half the >pins; i just wanted to see if anyone thinks if i should stop. by the way, i >pulled a small piece of the lamination off, so that's why there's a chunk >missing in one of the photos. > >thanks > >daniel carlton
This PTG archive page provided courtesy of Moy Piano Service, LLC