-----Original Message----- From: fssturm at unm.edu To: caut at ptg.org Sent: Tue, 9 Jan 2007 9:17 PM Subject: Re: [CAUT] TIP OF THE YEAR! On 1/1/07 2:58 PM, "kpiano" <kpiano at goldrush.com> wrote: > Nor I, just trying to give and get a visual of the procedures. How do you > solve the turning > over of the stack constantly to check the work? The way I have done it you can > travel a > shank, check it refine it, do the next one. Of course I'm talking a whole new > set of shanks, > just installed. Hi Keith, A late response: I do a section at a time rather than a shank at a time. I rough in a section, marking all hammers of shanks that need to be traveled "a good bit." I then set the stack upright, shim all those flanges, and check. I make a variety of marks to show more or less how much shim to use (longer, shorter, double line). Then I generally refine that section, and go on and rough in the next one. I establish three or four levels on the tail where I make marks, so I distinguish between passes, and know what I did before. It's kind of like leveling keys: do all the keys that need over 0.010" punchings first, then refine progressively on subsequent passes. For traveling, I usually find three passes is enough, sometimes four. I figure at the university I'll be back at the piano again in a year or five (if it is at all critical), and will re-refine it then. At which point two passes will probably be enough, starting from a better initial condition. I'll note that as you take care of the worst, it becomes easier to judge those that are closer. "Circles of refinement," as Mr. Mannino likes to say. A great concept for all our work. Regards, Fred Sturm University of New Mexico ________________________________________________________________________ Check out the new AOL. Most comprehensive set of free safety and security tools, free access to millions of high-quality videos from across the web, free AOL Mail and more. -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/caut.php/attachments/20070109/8007092b/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC