Thanks, David. I'll try making it. -John Parham Hickory, NC > -------- Original Message -------- > Subject: Re: [CAUT] Damper wire alignment (was:Underlever Felt) > From: "David Ilvedson" <ilvey at sbcglobal.net> > Date: Wed, August 26, 2009 11:28 pm > To: caut at ptg.org > Pianotek has it and it is exactly what it sounds like...a taut line to duplicate the string height section by section for blow, let-off, drop etc. > David Ilvedson, RPT > Pacifica, CA 94044 > ----- Original message ---------------------------------------- > From: johnparham at piano88.com > To: caut at ptg.org > Received: 8/26/2009 8:15:45 PM > Subject: Re: [CAUT] Damper wire alignment (was:Underlever Felt) > >Susan, > >I am new to this list. > >If you don't mind, what is the Taut Line regulation gauge? I tend to > >listen to good advise and try to make whatever kind of tools/jigs I can > >as a way to learn at the same time. > >If it's appropriate to contact me directly so as to not waste time here, > >that's fine with me. > >Thanks for any new ideas, > >John Parham > >Hickory, NC > >> -------- Original Message -------- > >> Subject: Re: [CAUT] Damper wire alignment (was:Underlever Felt) > >> From: Susan Kline <skline at peak.org> > >> Date: Tue, August 25, 2009 2:39 am > >> To: caut at ptg.org > >> At 07:22 PM 8/24/2009, you wrote: > >> >Well, that is a pretty cool idea. I will give it a try... > >> Jon is really good at this kind of stuff. > >> Remember the Taut Line regulation gauge? > >> Fantastic .... it is always in my kit, taking up so little > >> room and so light weight that I forget it's there till I > >> need it. > >> Susan Kline
This PTG archive page provided courtesy of Moy Piano Service, LLC