>...the core of the knuckle to line up with the jack center pin at rest. If the hammers are worn, you need to compensate for that during setup. Increase the blow distance by the amount lost from the original bore length. This will set the angle of the shank to original spec and consequentially the core angle. Make sure the wippen flange center is about 2.5" below the Hammer flange center. All this was covered very well in Bob Hohf's article "Action Elevations". -- Regards, Jon Page -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/caut.php/attachments/20090711/bedcb0db/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC