[CAUT] Half round

[Jim Busby]

Thanks Ron. 
Jim

________________________________________
From: caut-bounces at ptg.org [caut-bounces at ptg.org] On Behalf Of Ron Nossaman [rnossaman at cox.net]
Sent: Tuesday, July 28, 2009 5:23 PM
To: caut at ptg.org
Subject: Re: [CAUT] Half round

Jim Busby wrote:

> Where does one go for half round brass, or is it bronze? (for bearing
> points)

Since I'd likely not like the available heights, and either
have to stock a ton of choices or modify it to suit, I just
make my own in the first place from round stock.

Ron N