[CAUT] pin-block plugging?

[Ron Nossaman]

Jeff Tanner wrote:
> 
> ----- Original Message -----
>> I don't understand why this is so compelling a concept for so many. At 
>> the bottom is the last place I want a pin to be tight.
>> Ron N
> 
> I can think of one: pins driven so deep the coils are too close to the 
> plate to get ca in there.  Tight at the bottom is better than won't hold 
> at all.
> Jeff


Even in this instance, there's plenty of gap from above, where 
the wire diverges from the coil.

And since someone is dead sure to ask again - no, you won't 
glue the coil to the pin or plate.
Ron N