[CAUT] Hammer boring charts

[Jim Busby]

Yes! Thanks Ron

Jim

-----Original Message-----
From: caut-bounces at ptg.org [mailto:caut-bounces at ptg.org] On Behalf Of Ron Nossaman
Sent: Thursday, October 07, 2010 2:01 PM
To: caut at ptg.org
Subject: Re: [CAUT] Hammer boring charts

On 10/7/2010 2:20 PM, Jim Busby wrote:
> All,
>
> Several years ago I got an excellent hammer boring chart on line. I 
> think it was on CAUT. Well, I lost it, and while I pretty much know 
> how to bore it was nice to see all these "factory specs" and see where 
> they went with their boring angles, rake, etc. Sometimes it simply 
> helps me verify my own work, sometimes I change a bit towards what the 
> factory does. (Usually not)
>
> Does anyone have that chart? (Was it Newton? I can't remember, and 
> nothing pops up on a search)
>
> Thanks.
>
> Jim Busby


Is this it?
Ron N