Yes. Was this from Newton? Anyway, It’s a nice reference to have. Thanks. Jim From: caut-bounces at ptg.org [mailto:caut-bounces at ptg.org] On Behalf Of Mark Dierauf Sent: Thursday, October 07, 2010 2:18 PM To: caut at ptg.org Subject: Re: [CAUT] Hammer boring charts Is this what you're after? On 2:59 PM, Jim Busby wrote: All, Several years ago I got an excellent hammer boring chart on line. I think it was on CAUT. Well, I lost it, and while I pretty much know how to bore it was nice to see all these “factory specs” and see where they went with their boring angles, rake, etc. Sometimes it simply helps me verify my own work, sometimes I change a bit towards what the factory does. (Usually not) Does anyone have that chart? (Was it Newton? I can’t remember, and nothing pops up on a search) Thanks. Jim Busby -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/caut.php/attachments/20101007/d38bac0a/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC