Bill: For a problem similar to yours I placed strips of felt between wood and metal. I think I used pre cut flange bushing cloth. The fit was tight enough that I did not have to use glue, but would likely have used contact cement had it been necessary. The neat strips look nice. Hope this helps. Travis Gordy RPT Maxpiano@aol.com wrote: > > List - > > I never received any reply on this and figure it was because the list was > experiencing trouble. Forgive me if this is a repeat. > > I have a customer whose Gordon Laughead spinet was made with a couple of > panels in the music rack made up of heavy wire interwoven, maybe 3/4" > spacing. > > Every visit over the years, I have had some success quieting the rattle as it > wants to sing along with the music, but it gets worse from year to year. > I've bent wires, added glue, but any help was short-lived. Is there any > solution short of ripping out the wire and fashioning wood inserts to replace > the wire? > > Bill Maxim, RPT
This PTG archive page provided courtesy of Moy Piano Service, LLC