Ron, The damper bushing I was referring to is the brass bushing holding the set screw not the flange bushing. Although I have had to contend with someone's attempt to tighten flange bushings that way. You are correct, no a pretty sight. Jon Page Harwich Port, Cape Cod, Mass. (jpage@capecod.net) ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ At 12:48 PM 4/3/97 -0500, you wrote: >On Wed, 02 Apr 1997, Jon Page <jpage@capecod.net> wrote: > >> I have tracked down a few clicks to a slightly loose >> damper bushing. Glue sizing eliminated the clicking. > >I *know* you didn't mean GLUE sizing, right?! Water sizing, maybe (like I >suggested), but glue sizing a bushing is asking for real trouble! > > > Ron Torrella, RPT > Assistant Piano Technician > University of Michigan > School of Music > > > Jon Page Harwich Port, Cape Cod, Mass. (jpage@capecod.net) ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
This PTG archive page provided courtesy of Moy Piano Service, LLC