Hi, kjPaul, I once had a similar problem. There are two ways to solve this problemj. 1. There is a screw behind the action that rests against a plate brace. Remove this screw and replace the action. Get a BIG screwdriver and push against the action rail until it is straight. Replace the screw and make sure it touches the plate. 2. If the first method does not work remove the action and remove wippends from around the center of the bend. Place one end on the floor and hold the other end in your hand. Carefully place foot on bared section and push. Check for straightness. This is not difficult, just delicate. Newton nhunt@jagat.com
This PTG archive page provided courtesy of Moy Piano Service, LLC