Yes. I vote to keep factory specs!! (that's a joke) I think centered looks nice. Most are. Lance Lafargue, RPT New Orleans Chapter Covington, LA. lafargue@iamerica.net ---------- > From: Les Smith <lessmith@buffnet.net> > To: pianotech@ptg.org > Subject: Re: Fallboard decal > Date: Thursday, October 02, 1997 9:19 PM > > Okay, Jim. Get ready. > > I hope this reply isn't too simplistic, but if you measure the placement > of the old decal before stripping the fallboard, you'll know exactly > where to place the new one. Works for me! > > Les Smith > lessmith@buffnet.net > > On Thu, 2 Oct 1997 JIMRPT@aol.com wrote: > > > List; > > I suppose this falls in the category of a "wild hair" question but........ > > Is there a preferred placement of the fallboard decal in regards to height > > above the keys? > > I have always put them in the center or slightly above center, depending on > > size. But is this where they should go ? I put them there because that is > > where Iv'e always put them. Is there a general rule of thumb floating around > > ? Or a specific guideline, other than getting them as far from fingernails as > > possible and still look balanced? > > Jim Bryant (FL) > > >
This PTG archive page provided courtesy of Moy Piano Service, LLC