----- Original Message ----- From: Ron Nossaman <nossaman@SOUTHWIND.NET> To: <pianotech@ptg.org> Sent: Wednesday, August 18, 1999 9:47 AM Subject: Re: Was V-Pro, now welded plates > Del, > Out of curiosity, I did a little browsing in my Machinery's Handbook. The > casting shrinkage allowance for steel is listed as nearly twice that of cast > iron. That little tidbit, naturally, just raised more questions. Are you > having steel plates cast, or are you going to rivet them together and paint > them with iron oxide primer, like a bridge? As much as that appeals to me, I > kind of doubt that's what you're doing, so I'm assuming cast. Perhaps you've > got a small (even local) foundry cornered that is more flexible and will > work with you with small lots. Possibly cheaper too? --------------------------------------------------------- uh, who said anything about casting? Del
This PTG archive page provided courtesy of Moy Piano Service, LLC