Hi Judy, Make a saw kerf in the centre, about half way through. Glue one or two pieces of veneer in the kerf. You will probably have to hold one end of the board in a vice to bend it straight before fitting the veneer shims. PS you should dry fit the veneers and check for straightness before gluing. Regards Roger At 05:27 PM 14/02/99 -0800, you wrote: >Dear list, > > Recently I serviced a Chickering console where the nameboard strip >was bowed in the center and the sharps were knocking on it. It was only >anchored to the cheek blocks,with no anchor in the middle of the >keyboard. I tried moving the postion of the screws in the cheek blocks, >but I don't have to much room to play.The sharps still knock in the >middle of the keyboard.I'm at a loss on how to fix this problem. Any >ideas.? Thanks > Judy Kazanjian > associate{soon to be RPT} > Reading-Lancaster Chapter > >______________________________________________________ >Get Your Private, Free Email at http://www.hotmail.com > Roger Jolly Baldwin Yamaha Piano Centre Saskatoon and Regina Saskatchewan, Canada. 306-665-0213 Fax 652-0505
This PTG archive page provided courtesy of Moy Piano Service, LLC