Clyde, Use CA glue before the pins have been driven in too far. If they are too tight after using CA they can be tapped in a smidge to loosen the glue bond and will tune great.Joe Goss ---------- > From: Clyde Hollinger <cedel@redrose.net> > To: pianotech@ptg.org > Subject: Re: CA vs Epoxy for pinblocks > Date: Tuesday, January 26, 1999 3:40 PM > > Don: > > I assume the pins that sheared off were doped with CA glue, or was it > something else? I considered trying CA glue on some of these old > clunkers, but if this can be the result, it's a problem I can do > without, for sure! > > Clyde Hollinger > Lititz, PA > > Don wrote: > > > > Hi, > > > > I don't think there was a debate really over CA vs epoxy. More of an > > offering of opinions. I have yet to try epoxy on a pin block, but would > > love to! > > > > On a doped block for me the pins actually became so tight they were > > shearing off. > >
This PTG archive page provided courtesy of Moy Piano Service, LLC