I have a real aversion to lifting the skid for the dolly. Could the "horse" work with the skid on the dolly before tipping? David Ilvedson From: "Brian Trout" <btrout@desupernet.net> To: <pianotech@ptg.org> Subject: Re: Tilting on the lyre Date sent: Mon, 31 May 1999 11:52:39 -0400 Send reply to: pianotech@ptg.org > Anybody got a jpeg image, or something like that? Man, I'm curious!!! > > Brian Trout > > -----Original Message----- > From: Avery Todd <atodd@UH.EDU> > To: pianotech@ptg.org <pianotech@ptg.org> > Date: Monday, May 31, 1999 10:49 AM > Subject: Re: Tilting on the lyre > > > Hi Jim, > > I'll try but I'm sure there's someone else who's actually used it who > could do a much better job, plus I've only seen it used once or twice. > The bass corner is lifted up enough to place the tilter under the > keybed toward the treble end. This suspends the bass leg so one person > can remove it. On the treble end there is an arrangement of some kind > (this is where my memory is vague) that attaches to that leg. Because > of the angle of the piano when it comes down, the instruction videotape > which comes with it recommends placing a 2x4 (I think it is) piece under > the tail end of the skid before tilting the piano. Then it is simply > rolled over onto the skid (pedals not touching the floor) and the entire > long side touches the skid at app. the same time. Push it on up as usual, > remove the lyre and other two legs and that's it. With the 2x4 under the > skid, it also makes it a little easier to lift to place the dolly under > it. > What I particularly liked about it was that the only real lifting > stress on the mover is when the skid is tilted to place the dolly. > I hope I've remembered this fairly accurately. If I haven't, someone > please feel free to correct me. > > Avery > > >Would it be possible for you to describe in a little more detail how this > >Horse works, where you put it, if it interferes with the skid board etc.? > > > >Jim Coleman, Sr. > > > >On Sun, 30 May 1999, Avery Todd wrote: > > > >> Bill & List, > >> > >> Someone else has mentioned The Piano Horse. I will strongly second the > >> use of it. With this, there is no need to take the time to romove the > lyre, > >> install dummy, remove dummy, reinstall lyre. > >> Once it's in position, the left leg is high enough for one person to > >> remove the leg, then the entire piano is rolled on over onto the skid > >> without the lyre even touching the floor. Then the lyre and legs are > >> removed as usual. Reverse the procedure for setting it back up. > >> I don't have one but have seen it in operation at a dealership I do > some > >> work for. It's so simple, I've even considered getting one to use with > the > >> occasional "in-house" moves here. It's one of those "Now why didn't I > think > >> of that" things. > >> > >> Avery > > > David Ilvedson, RPT Pacifica, CA ilvey@jps.net
This PTG archive page provided courtesy of Moy Piano Service, LLC