Clark wrote: > > Paul, > > So they're kind of reverse tapered pins? I hope I'm not stepping on your toes > to ask, but I need two sets of custom pins made and was wondering if Klinke > made you samples or if you had them made through other means. > > Mine are definitely not marketable! They're very long and tapered, threaded > and with the becket hole on the bottom, ala Robert Wornum and Cristofori. > shhh...low tension reproductions. > > Regards, > > Clark Panaccione Well....they're not really tapered at all. They're of one diameter from the top to 4mm below the becket and of another for the remainder, with "step" or transition area between the two. Klinke is going to make a batch, but I doubt if they would custom make two sets. Paul
This PTG archive page provided courtesy of Moy Piano Service, LLC