If the original holes are destroyed to the rail is not holding well get some T-Nuts of just the right size. Enlarge the hole enough to accept the barrel of the T-Nut and drill tiny holes through the finish to accommodate the retaining pins. Drive them into place and reinstall the rail. Adjust according to my other post. It should work. Newton Dpshans@AOL.COM wrote: > > No, actually both ends are attached. A previous tech tried to solve the > problem by drilling new pivot holes, and moved the attachment points, to no > avail. He gave up, client not happy, so they called me. My first step will > be to move the assembly back into the original holes, and start from there. > > Dan
This PTG archive page provided courtesy of Moy Piano Service, LLC