I cannot find the name/address of the quarter sawn spruce supplier I bought boards from (years ago now)to make shims with. They were in the northwest. I use the Spurlock router jig/bit. Anyone have his directions with the names/addresses of suppliers or know of someone closer than Canada for this? Unlike Kevin (below), I don't have to have it longer than 5 feet. Thanks! Lance Lafargue, RPT Mandeville, LA New Orleans Chapter lafargue@iamerica.net -----Original Message----- From: owner-pianotech@ptg.org [mailto:owner-pianotech@ptg.org]On Behalf Of Kevin S. Riggs Sent: Tuesday, October 19, 1999 8:19 PM To: pianotech@ptg.org Subject: Source for soundboard spruce Anybody out there have a source for quarter sawn spruce planks for soundboards? I'd like to try some ideas out, but I'm having difficulty finding long enough boards. If you'd prefer you can email privately at lobeliac@ipass.net Thanks in advance, Kevin Riggs Youngsville, NC RTP chapter
This PTG archive page provided courtesy of Moy Piano Service, LLC