Hi Ron, Thank's for the tip. Like all good ideas is so simple. Sure will cut down on the flying swarf that I usually have. Roger > >Double drilling works fine too. a 1/4" hole with the first pass clears out >the bulk of the material, and it's not critical to keep the bit cool >because it's just a rough-in. A second pass with the final size bit removes >so little material that the bit doesn't tend to overheat nearly as much and >I think I can get a more uniform result this way. > > > >Ron N > Roger Jolly Saskatoon, Canada. 306-665-0213 Fax 652-0505
This PTG archive page provided courtesy of Moy Piano Service, LLC