At 02:04 PM 04/01/2000 -0500, you wrote: >I was curious about what kind of on the sight tools tuners use to tighten >plate bolts. I have tried different tools through the years and sometimes >still struggle to get them tight. Men check your tool boxes and report back >if ya can........ please. >BP 3/8" drive rachet with extensions. Minimal set of sockets for bolts. Craftsman is good for the cross bits (phillips). Snap-on for the slot bits and all screw drivers, accept no substitutes. A rachet is more versatile than the slot bit adapter for the tuning hammer. Regards, Jon Page, piano technician Harwich Port, Cape Cod, Mass. mailto:jonpage@mediaone.net ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
This PTG archive page provided courtesy of Moy Piano Service, LLC