Jim, Hadn't thought about it. But, now that you mention it, why not? Thanks, Del ---------------------------------------------------------- ----- Original Message ----- From: <JIMRPT@AOL.COM> To: <pianotech@ptg.org> Sent: June 04, 2000 9:14 AM Subject: Re: Re: Plate Bushings - was Re: Bushing vs. bigger pin? > > In a message dated 6/03/2000 2:02:29 PM, you wrote: > > <<My best results -- at the time -- were obtained with a block that ended up > > approximately 38 mm (1.5") thick. The lower (away from the plate's tuning > > pin panel) 23 mm (+/-) was made up of 15 1.5 mm rotary cut maple veneers > > with the upper 15 mm (+/-) being made up of 1.0 mm rotary cut maple veneers. > > Actually there were only 13 plies in the upper portion. The remaining 2.5 > > mm was made up of the glue lines at approximately 0.1 mm (0.004") each. > > >> > > Del; > Interesting description. Any further illumination/discussion in the book? > Jim Bryant (FL)
This PTG archive page provided courtesy of Moy Piano Service, LLC