Carol, Did you first remove the strings or were you able to get the glue past the string? Joe Goss From: Carol Beigel <carolrpt@hotmail.com> To: <pianotech@ptg.org> Sent: Monday, June 19, 2000 6:48 AM Subject: Re: Bridge Pin/Epoxy Question > One method I used years ago to tighten bridge pins was to use a big 1/2" tip > on a soldering iron (reached all three bridge pins at once) and apply marine > resin at the base of the pins. Since marine resin is so thin, there is no > clean up. Once the iron was hot, the entire piano could be done in about an > hour! > > Carol Beigel, RPT > > > > ________________________________________________________________________ > Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com > >
This PTG archive page provided courtesy of Moy Piano Service, LLC