Hmmmm, RU saying that the bottom of the key is not does not lie in a plane parallel to that of the keytop? Even if the key were twisted, the bottom and top would still be parallel in any given area. Please explain, I must be missing something. Terry Farrell Piano Tuning & Service Tampa, Florida mfarrel2@tampabay.rr.com ----- Original Message ----- From: "Paul McCloud" <smccloud@ix.netcom.com> To: <pianotech@ptg.org> Sent: Thursday, March 16, 2000 12:59 AM Subject: Re: jig for keytops > I have this planer also, and have used it with my own version of a key > jig. The photo shows a very large radial press, which is much bigger > than our table top drill press. I used a vise from Sears which has a > special handle to tighten the jaws. I used this to hold the key while > planing the top. I mounted a piece of flat ply on the press table, and > slide the key under the planer in the vise. > My problem has been that the keys often have some twist in them, so > the bottom of the key isn't flat, and the top gets planed at an angle, > and the keyfronts lay at an angle. YIKES!. What I would like to see is > some way of using the original keytop to set the planing surface on the > machine. What I would envision is sort of like using a jointer (key > upside down). The original plane of the keytop is the best reference to > use, since it doesn't rely on the other surfaces of the key. Any ideas? > > Paul McCloud > >
This PTG archive page provided courtesy of Moy Piano Service, LLC