Hi Greg, Try some protec cpl on the bearing surfaces. It will allow you to stabilize the piano--so far as I know you will need to repeat the treatment on each visit. It may take less as time goes on. At 01:16 PM 3/30/00 -0500, you wrote: >Hi again, > Have any of you ever run into jumpy string? I've been tuning a >Steinway B in a music school for quite a few years now and it's finally >getting to the point where it's almost impossible to tune. Much of this >depends on my mood too as to whether or not I want to screw with it. >Just like jumpy pins you are nearing the point where you want the string >and it jumpy too high or too low. The pin does, however, turn smoothly. >I've tried teflon powder on the understring felt and other lubes at the >agraffe to no avail. The feedback I get from my trusty rosewood tuning >hammer says that the problem is near me not at the other end of the >string. I hear something like ticks with the pitch rising if you can >imagine that. Any ideas? I'm thinking restringing here if the school can >get a grant for the money. I'm fairly sure that would cure the problem, >I'd just like to understand it a little better. Feel free to share any >insights, s.w.a.g. 's or the like. > Greg Newell > > > Regards, Don Rose, B.Mus., A.M.U.S., A.MUS., R.M.T., R.P.T. Tuner for the Saskatchewan Centre of the Arts drose@dlcwest.com http://donrose.htmlplanet.com/ 3004 Grant Rd. REGINA, SK S4S 5G7 306-352-3620 or 1-888-29t-uner
This PTG archive page provided courtesy of Moy Piano Service, LLC