Don, I thank you for your post but what I'm really trying to do is understand why the problem is there. I'm sure there are many remedies that would mask it for a time but what caused it in the first place? Admittedly I didn't check as closely as I should have but I was hoping that someone would have run into this before and have a quick answer. Greg Don wrote: > Hi Greg, > > Try some protec cpl on the bearing surfaces. It will allow you to stabilize > the piano--so far as I know you will need to repeat the treatment on each > visit. It may take less as time goes on. > > At 01:16 PM 3/30/00 -0500, you wrote: > >Hi again, > > Have any of you ever run into jumpy string? I've been tuning a > >Steinway B in a music school for quite a few years now and it's finally > >getting to the point where it's almost impossible to tune. Much of this > >depends on my mood too as to whether or not I want to screw with it. > >Just like jumpy pins you are nearing the point where you want the string > >and it jumpy too high or too low. The pin does, however, turn smoothly. > >I've tried teflon powder on the understring felt and other lubes at the > >agraffe to no avail. The feedback I get from my trusty rosewood tuning > >hammer says that the problem is near me not at the other end of the > >string. I hear something like ticks with the pitch rising if you can > >imagine that. Any ideas? I'm thinking restringing here if the school can > >get a grant for the money. I'm fairly sure that would cure the problem, > >I'd just like to understand it a little better. Feel free to share any > >insights, s.w.a.g. 's or the like. > > Greg Newell > > > > > > > Regards, > Don Rose, B.Mus., A.M.U.S., A.MUS., R.M.T., R.P.T. > Tuner for the Saskatchewan Centre of the Arts > drose@dlcwest.com > http://donrose.htmlplanet.com/ > > 3004 Grant Rd. > REGINA, SK > S4S 5G7 > 306-352-3620 or 1-888-29t-uner
This PTG archive page provided courtesy of Moy Piano Service, LLC