Good advise! I don't use sprays but the possibility still exists with liquid. Greg Piano Services Tech Dept wrote: > Greg, > Just a word of caution. Be careful what you spray on the strings. I came > across a piano which a tuner sprayed WD-40 on the strings over the pressure > bar felt before the agraffes. It traveled back to the tuning pins, down into > the tuning pin holes and the T pins were slipping. We had to restring this > 12 year old Steinway L and ream out the holes to get to fresh wood. A real > shame. > > Ed Mashburn RPT. > ----- Original Message ----- > From: Greg Newell <gnewell@EN.COM> > To: <pianotech@ptg.org> > Sent: Thursday, March 30, 2000 1:16 PM > Subject: Jumpy strings? > > > Hi again, > > Have any of you ever run into jumpy string? I've been tuning a > > Steinway B in a music school for quite a few years now and it's finally > > getting to the point where it's almost impossible to tune. Much of this > > depends on my mood too as to whether or not I want to screw with it. > > Just like jumpy pins you are nearing the point where you want the string > > and it jumpy too high or too low. The pin does, however, turn smoothly. > > I've tried teflon powder on the understring felt and other lubes at the > > agraffe to no avail. The feedback I get from my trusty rosewood tuning > > hammer says that the problem is near me not at the other end of the > > string. I hear something like ticks with the pitch rising if you can > > imagine that. Any ideas? I'm thinking restringing here if the school can > > get a grant for the money. I'm fairly sure that would cure the problem, > > I'd just like to understand it a little better. Feel free to share any > > insights, s.w.a.g. 's or the like. > > Greg Newell > >
This PTG archive page provided courtesy of Moy Piano Service, LLC