This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment I'm coming in a little late on this, but have you tried to re-tap the = hole? If I remember correctly, the hole was drilled out, but what was = the final diameter? If you drilled far enough to begin to see cast iron, = there should be enough material to re-thread. Sorry if this has been = suggested and I missed it. Paul Chick ----- Original Message -----=20 From: BUNKYPIANO@AOL.COM=20 To: pianotech@ptg.org=20 Sent: Sunday, November 19, 2000 4:47 AM Subject: Re: Frozen Agragge are you sure you got the old agraffe out? The cast iron is much = harder than=20 brass, could it be you were using an undersize and just screwing into = the=20 brass left, try to get it all out...=20 tm=20 ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/f0/f9/19/84/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC