>Hi folks. I am repinning the bridges on an old square grand today (or rather >I was) when I realized I do not have the proper size pin for the treble >area. The old pins were 0.068" diameter. This would be a about a #5 pin. I >checked catalogs from Pianotek, Schaff & APSCO and the smallest pins they >have are #6 pins which are 0.076" diameter. It is super tight quarters in >this area of the bridge, and I fear that using the #6 pins may cause >problems. Anyone know of a source for #5 pins? > >Terry Farrell Just out of curiosity, I checked out a couple of web listings of harpsichord supplies and only found 0.063" pins. A #26 flange center pin is 0.066", for what it's worth. They're in the APSCO and Pianotek catalogs. I don't know that they are hard enough material for bridge pins, but... Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC