Jon, I agree with the thought of doing away with the slotted screws on the whips, but do and I both know that they aren't going to do that anytime soon, and even if they did, there will still be millions of pianos out there which have 'em. To ease your frustration with these things, I strongly suggest that you get one of the "Double Grand Drop Screwdrivers" from Pianotek- part JDD-3. I did, and it's one of those tools that I wouldn't be without. Fits right over those drop screws and Baldwin rep-spring screws and won't slip off. I've had mine for a couple years now, probably last a life time. Hope this helps. ----- Original Message ----- From: "Jon Page" <jon.page@verizon.net> To: <pianotech@ptg.org> Sent: Saturday, August 11, 2001 6:25 PM Subject: Another "tradition" which should be dismissed... > > Slotted repetition lever upstop screws (drop screws) which have a slot for > a small screw driver. > The 'tab' variety are much easier to position the 'drop screw' driver. It's > a no brainer... > > I do not see a need for the 'slotted' type. Having worked on many actions, > there have been failure rates on both types in equal amounts. > > Where the 'tab' type is effortlessly adjusted, the 'slot' type requires > some investigation (takes longer). > I'm surprised the man'f'r's haven't had this light dawn on them. > > The only thing I see perpetuating this inconvenience is "tradition". > > Don't go against that... > > I'm a known up-start so it is no surprise that I'd be complaining about > this known up-stop. > > Regards, > Jon Page, piano technician > Harwich Port, Cape Cod, Mass. > mailto:jon.page@verizon.net > http://www.stanwoodpiano.com > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
This PTG archive page provided courtesy of Moy Piano Service, LLC