Don; I just try to do the most stable tuning possible, and hope that it's lasts as long as possible. I know it's going to start going out of tune the next time the customer touches the thermostat, but if I lied awake at nights worrying about the inevitable, I wouldn't be doing anyone any good. Physics, after all..... ----- Original Message ----- From: "Don" <drose@dlcwest.com> To: <pianotech@ptg.org> Sent: Thursday, August 30, 2001 8:21 AM Subject: Re: stability of pitch raises > Hi Tom, > > The structures do move later. Next time you find a piano that is dead on > A440, try using small pitch raise mode. I beleive you will be surprised how > much other areas of the piano can be "out" under these circumstances. > > There is always environment as well. 5% RH humidity change moves a small > upgright piano at A4 approximately 4 cents. If the whole piano would > shift--fine, but of course this is not so. Clients can easily hear a 1 cent > differencial in an octave. Whether they find it offensive is another > (subjective) question. > > At 09:56 PM 08/29/2001 EDT, you wrote: > >I do all my pitch raises using RCT, so I end up very close to pitch after > the > >first pass. > > Regards, > Don Rose, B.Mus., A.M.U.S., A.MUS., R.M.T., R.P.T. > > Tuner for the Saskatchewan Centre of the Arts > > mailto:drose@dlcwest.com > http://donrose.xoasis.com/ > > 3004 Grant Rd. > REGINA, SK > S4S 5G7 > 306-352-3620 or 1-888-29t-uner
This PTG archive page provided courtesy of Moy Piano Service, LLC