Mark, Clark I've used brushable water based finishes on several projects and I'm very pleased with the results. It levels easily between coats by sanding or scraping and buffs to a nice lustrous finish. Durability seems better than solvent based spray lacquer. Paul Chick ----- Original Message ----- From: <bases-loaded@juno.com> To: <pianotech@ptg.org> Sent: Tuesday, December 11, 2001 6:29 AM Subject: Re: Piano Finishes > Hi Clarke - > > One other thought worth considering, I think, is to check out the newer > brushable water-based finishes. I have never brushed water-based > material myself ( I spray them) but a customer of mine just refinished > his upright using a finish he purchased at Rockler's Woodworking Store > and the results, especially for a first timer, were magnificent. I > believe he said the finish was made by "General Finishes". Worth a > look-see, I would think, because there is practically no fumes, quick > drying, good build, and can be formally rubbed out if desired. Tinting > the finish can be accomplished with either water-based dyes, or using the > newer Transtint dyes. > > A good low-tech, low VOC finish. > > Mark Potter > bases-loaded@juno.com > > > > On Mon, 10 Dec 2001 22:44:53 -0500 "Clark A. Sprague" > <clarks11628@juno.com> writes: > > May I ask a further finishing question? How about a Tung Oil finish > > on a > > grand? I am currently re-whatevering a Baldwin R (1943) that is > > mahogany, with I think Laquer applied. There are various gouges, > > etc, > > which will need to be filled. I was wondering, without the proper > > spray > > equipment, as of now, what kind of finish would be good to hand > > apply? > > Any experience with Tung Oil on a piano? > > I put it on a rocking horse that I made for my daughter > > years > > ago, and it has held up well. So why not on a piano? > > Clark Sprague > > >
This PTG archive page provided courtesy of Moy Piano Service, LLC