Leading question Counselor... David I. *********** REPLY SEPARATOR *********** On 2/21/01 at 4:23 PM John M. Formsma wrote: >Dave Carpenter wrote: > ><<There are a multitude of other note sequences that could be used that may >give the tuning calculator a better idea of the inharmonicity earlier on in >the tuning process. One easy example might be: A4, A3, A3-up, A3-down. Of >course the extreme case is to tune the piano twice. Many tuners regularly >do >this anyway. In this case, the entire inharmonicity picture is known before >you start, for every note, and an incredibly smooth tuning can be >calculated. Since the Verituner can save these measurements for later use, >you can recall these measurements on repeat tunings and get a similar >effect.>> > >Based upon what you have written above, and in your earlier post, I assume >that one could get a quite good tuning by measuring/tuning all the A's, the >notes around the bass break, and/or the high inharmonicity strings in small >scale pianos (such as the Acrosonic where the plain wire strings start). >Measuring the inharmonicity of these would give more information for >calculations. Correct? > >Thanks, > >John Formsma >Blue Mountain, MS > >mailto:jformsma@dixie-net.com p
This PTG archive page provided courtesy of Moy Piano Service, LLC