New Guide Rail Tool

[Lance Lafargue]

I usually ease guide rail holes with a traditional easing tool.  When
severe,
as it often is here in the south, I take the dampers out and iron them with
a bridge pin (in brass rod) chucked into a key easing iron with thermostat.
This works great.  My question is:  Has anyone tried to chuck a guide rail
easing tool (just the metal business end) into an iron in order to ease/iron
without removing the dampers?  Thanks,


Lance Lafargue, RPT
Mandeville, LA
New Orleans Chapter, PTG
lancelafargue@bellsouth.net