Oh great. Now that I finally found a good source for damper felt! Figures. :-( > >Try the Tokiwa pre-cut dampersets from Pacific/Brooks to replace > >the loss of Yamaha parts. So, who/what is Tokiwa? Where did they come from? I realize they make action parts. What else do they make? Where are they located. Are they just a little (big?) company that make action stuff? Kinda like a Renner-Korea (or wherever)? Terry Farrell ----- Original Message ----- From: "Bill Ballard" <yardbird@pop.vermontel.net> To: <pianotech@ptg.org> Sent: Wednesday, October 24, 2001 6:10 PM Subject: RE: Yamaha Quits Schaff > At 12:26 PM -0500 10/24/01, John M. Formsma wrote: > >Before we all get out of sorts, is this confirmed and what is the source(s)? > > Danielle at Schaff. (snip (Ron!)) > At 6:30 AM -0700 10/24/01, DALE ERWIN wrote: > >Try the Tokiwa pre-cut dampersets from Pacific/Brooks to replace > >the loss of Yamaha parts. > > These are very good felts. The flats for the most part don't oink, > but I did run into some difficulty with the plain tri-chord wedges on > a M&H AA whose gaps between strings on a note were a little wider > than the size of these Tokiwa wedges. I'm going to miss the vertical > felts the most (the U1 and U3 sets). > > Bill Ballard RPT > NH Chapter, P.T.G. > > "I'll play it and tell you what it is later...." > ...........Miles Davis > +++++++++++++++++++++ >
This PTG archive page provided courtesy of Moy Piano Service, LLC