---------------------- multipart/alternative attachment In a message dated 9/25/01 11:28:01 PM Central Daylight Time, mfarrel2@tampabay.rr.com writes: > To address Wim's comment to replace flanges with > spring - the flanges I have found have an off-centered rail screw hole - I > need hole in middle of flange - besides, I kinda want to do this so that I > have done the whole thing for experience. > I can understand the experience thing. Good luck. I hope you learn a lot from this. As far as the off center hole is concerned, I don't quite understand. The damper flanges I have seen have the hole in the middle. But even if they are off centered, you can use them, but then adjust the damper wire to move the damper head over to the string. Wim ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/7c/99/b9/b8/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC