At 05:26 PM 4/10/2002 -0400, you wrote: >Hi Richard, > > > if I go for a shorter bore.. then I exasperate the problem with drop > screws If the shanks were changed, perhaps a different knuckle diameter or radius from the flange center was introduced. Then again, you could examine the thickness of the cushion which interacts with the repetition lever upstop screw. No puzzle, just trouble... Regards, Jon Page, piano technician Harwich Port, Cape Cod, Mass. mailto:jonpage@attbi.com ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
This PTG archive page provided courtesy of Moy Piano Service, LLC