Exactly. Unusual construction/design. I would only suggest doing a couple more standard pianos first so that you have some idea of what goes on in thar before you dig into such an odd duck. I have a Steinway and two Mason & Hamlin uprights that I will rebuild - but I will do at least one more standard upright first. Recently I took apart (and I mean completely apart!) two uprights. A Starr and a Knabe. What a world of difference. The Starr was very simple and straight forward. The Knabe was quite a bit more complex with its full pin block flange and bottom flange in the plate. Even just tearing these old junkers apart was quite an education. Good Luck! Terry Farrell ----- Original Message ----- From: "Tyler Punky Smith" <macman@pathfinder.dnsalias.com> To: <pianotech@ptg.org> Sent: Monday, April 22, 2002 3:48 AM Subject: Re: Tyler Smith/Chickering Upright > >Tyler, > >My advice is leave it alone. Or, at least refer it to someone with a lot of > >experience. There are two pianos that are no-no's for beginners: Chickerings > >and Steinways, (Uprights, that is). Discretion is the mark of valor. > >Regards, > >Joe Garrett, RPT, (Oregon) > > This is because of it's nonstandard construction, or some other reason? > It certainly is an odd piano. Understanding is the path to > discretion. :-) > > -Tyler
This PTG archive page provided courtesy of Moy Piano Service, LLC