This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Something may be holding the action up too high maybe. Carl Meyer Assoc. PTG Santa Clara, California cmpiano@attbi.com=20 ----- Original Message -----=20 From: HazenBannister@cs.com=20 To: pianotech@ptg.org=20 Sent: Wednesday, April 24, 2002 1:51 PM Subject: Blocking hammers Hi list,=20 I went to a Youg Chang today,about 10 years old,for a tuning.I tuned = it once about 3 or 4 years ago.I got there and every hammer was = blocking,I'm not talking about buzzing,but major blocking.I did'nt have = enough time to get into it as I had an appointment conflict.So I'm going = back tomorrow to fix this ,pitch raise ,clean,and tune.(it's a grand = with a piano-disc system).I checked to see if any rails were loose,or = might have shifted,is there anything I should look for,maybe with the = player system?I changed letoff on a few notes,and it quit blocking,but I = sure had to twist them a mile,it has the dowel type.It also has = excessive keydip.I guess I should go through one note and completely = regulate,I am just checking to see if there's something obvious,maybe = I've overlooked.=20 Thanks in advance,=20 Hazen Bannister=20 ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/fe/fd/32/c4/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC